Remotec ZXT-310 V1.2 Manual do Utilizador descarregar pdf (Página 14)

seconds

• Learnacode

successful

5 Repeatstep2to5tolearnotherkeys. ‐

Note 1: Red LED flashes 6 times means that the setup process is failed.

Please redo the process again.

Note 2: On step 4, if no IR signal received for more than 15 seconds,

the Error LED in front will flashes six times then all LED turn off,

Learning on ZXT-310 mode will exit automatically.



LWhenyouencounterproblem,checkfollowings:

− Makesureyouroriginalremoteisswitchedtopoweroff.

− Press the key on original remote before learning mode

timeout.

− Keepawayfromincandescentlightanddirectsunlightduring

learning.

− MakesureIRTransmitterof your original remotealightwith

learningdiodeofZXT‐310,youmayalsoslightadjustcloseror

further away  the distance of two devices. Some of remotes

theIRtransmitterinhiddenbehindlensandmaynotinstalled

centerofremote.

− Makesure thepowerisgoodon both devices,especially the

originalremote.Usefreshbatteries.



ResetZXT‐310tofactorydefault



Pressandhold“PROG”buttonfor10secondsonZXT‐310,LEDwill

flashuntilresetprocessiscompleted.



1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

Sem comentários

Remotec ZXT-310 V1.2 Manual do Utilizador Página 14