Remotec ZXT-310 V1.2 Manual do Utilizador descarregar pdf (Página 11)

IRPortMapping

MappingindividualChanneltoindividualPortinZXT‐310



LImportant

− Please make sure that the “End point selection control” has

completed(ifnecessary)beforeprocessthefollowingsetup.



Step SetupKey

LEDIndication

Statuson

ZXT‐310

1

MakesureZXT‐310switchedto

Channel1(EP1)

• LEDflashes

oncethen

keepon

2

Refertoyourprimarycontroller

instructionstoprocessthe

configurationsetupprocedure.

‐Parameter:29

‐Value:01

(EntertheIRportnumber1‐6which

youwanttotransmittheIRsignal)

‐

3

PressthePROGbuttonon

ZXT‐310

• LEDflashes

twicethen

keepon

• SetIRPort

output

successful

Note 1: Red LED flashes 6 times means that the setup process is failed.

Please redo the process again.

Note 2: All the Simple AV Channel / Z-Wave-to-IR Channel will map to

“IR Port 1” by default if user has not go through the above setup

procedure or Z-Wave remote controller does not support “Multi-

channel Command Class”.



1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Sem comentários

Remotec ZXT-310 V1.2 Manual do Utilizador Página 11