Remotec Multimedia Master Remote Guia do Utilizador descarregar pdf (Página 16)

Cytavision installation guide • chapter 4 - remote control

4.2.1 Manual Brand search

In order to manually introduce the TV code, you must

follow these steps:

1. To begin the procedure your TV must be switched on.

2. Press and hold the digits “1” and “3”

simultaneously for a minimum of 3 seconds.

3. After 3 seconds, the TV LED on the remote control

will turn on. Release the keys.

4. Now enter the 4-digit code for the appropriate TV

brand (please refer to APPENDIX A). When a digit is

pressed, the TV LED gives a short inverse blink and

after the fourth digit is entered, the remote checks if

the 4-digit code is valid.

5. If correct, the TV LED will do a confirmation blink

and remain switched on. If the code is not valid, the

remote control will execute an error-blink and return

to normal operation mode.

6. Then hold the Power or Mute key; after 2 seconds,

the TV LED will blink during transmission of the code. If

the TV is turned off or goes mute depending on which

button was pressed for 2 seconds, it means that the

right code was transmitted.

7. When the right code is transmitted, release the

Power or Mute button and normally the TV will be

turned off or go mute respectively to indicate that the

correct code was transmitted.

8. Press HOME and STOP key simultaneously to save

your set up after getting the correct codes.

4.2.2 Auto Search

Ifyouarenotabletofindthepropercodefora

particularbrandofequipmentlisted,ornoneofthe

listedcodesforthatbrandseemtowork,please

performanautocodesearchoftheentirecode

databaseforthatmode.

InordertointroducetheTVcode,youmustfollow

thesesteps:

1.TobegintheprocedureyourTVmustbeswitched

on.

2.Pressandholdthedigits“1”and“3”simultaneously

foraminimumof3seconds.

3.After3secondstheTVLEDoftheremotecontrolof

STBwillturnon.Releasethekeys.

4.Nowpressthedigits“0000”forautosearch.

5.Ifcorrect,theTVLEDwilldoaconfirmationblinkand

remainon.

Ifthecodeisnotvalid,theremotecontrolofSTBwill

performanerror-blinkandreturntonormaloperation

mode.

6.ThenpressandholdthePowerorMutekey;after2

secondstheremotecontrolwillstartauto-search.You

mustkeepholdingthebuttonuntiltheTVreacts.The

TVLEDwillblinkduringtransmissionofthecode.This

operationmaytakeawhileastheremotecontrolis

searchingthroughhundredsofdifferentTVbrands.

7.IfyoupressthePowerkey,whenfindingtheright

code,theTVwillturndowntoindicatethatthecorrect

codeisfound.IfyoupresstheMutebutton,when

comingacrosstherightcode,theTVwillbemutedto

indicatethatthecorrectcodeisfound.Afteraccessing

therightcode,releasethePowerorMutebutton.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 38 39

Comentários a estes Manuais

Sem comentários

Remotec Multimedia Master Remote Guia do Utilizador Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Remotec Multimedia Master Remote