Remotec Z-URC550 V1 Manual do Utilizador descarregar pdf (Página 18)

Press the program/EP

button on the secondary

device (e.g. light switch)

• “OK＂ LED flashes

once and stays on

• “LED_B＂ flashes once

and keep blinking slowly

Press the program/EP

button on the primary

device (e.g. door sensor)

• “LED_B＂ turns off

• “OK＂ LED flashes

once then turns off

• Assigning association

completed

Note1: Your target device must be included in the network before this

setup procedure, please refer to [Adding Device to the Network]

section.

Removing Device/End-point from an Association Group

Step Setup Key LED Indication Status

Press in Advance

Setup

• The “OK＂ light turns

Press

• “OK＂ LED flashes

once and stays on

• “LED_A＂ flashes

slowly

Select a group number

from 1 to 16 (1-8 or

1-8)

• “OK＂ LED flashes

once and stays on

• “LED_A＂ off

• “LED_B＂ flashes

slowly

Press the program/EP

button on the secondary

device (e.g. light switch)

• “OK＂ LED flashes

once and stays on

• “LED_B＂ flashes once

and keep blinking slowly

Press the program/EP

button on the primary

device (e.g. door sensor)

• “LED_B＂ turns off

• “OK＂ LED flashes

once then turns off

• Device removed from the

association group

successfully

Note1: This process will only remove the target device/EP from its

assigned association group but will not exclude it from the network.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comentários a estes Manuais

Sem comentários

Remotec Z-URC550 V1 Manual do Utilizador Página 18

Comentários a estes Manuais