Remotec ZXT-120 Manual do Utilizador descarregar pdf (Página 3)

Remotec Technology Limited

Room 2907-2908, Skyline Tower, 39 Wang Kwong Road, Kowloon Bay, Hong Kong • 楁㷗ḅ漵䀋⬷⃱忻 39 嘇⬷⣑⺋⟜ 29 㦻 2907-2908 ⭌

Tel 暣娙 : (852)-2314 0330 • Fax ⁛䛇 : (852)-2314 1006 • Website 䵚⛨ : www.remotec.com.hk

Scene Learning:

Basically, end user is able to operate it referring to the above parameter table using the Configuration function on

the gateway, below is an example for leaning a combination (scene) of: “cool, temperature 21 C, fan high,

swing”:

1, Use the original A/C remote to set the A/C status to one step ahead or one step behind your desired status, for

example: your desired condition is: “cool, temperature 21C, fan high, swing", it is better to set the temperature to

cool, 20 C (or 22 C). Fan high, swing", doing so is to prepare for pressing one button to proceed the learning

action when the ZXT-120 is set to leaning condition"

2, Make sure ZXT-120 is included to gateway, go to Configuration Set, put parameter: 25(parameter number for

learning), 1 Byte Dec (parameter size), 3 (parameter value) (it is the location for the learnt codes in ZXT-120).

3, save the above parameters, gateway will send the set parameters to the ZXT-120,

4, ZXT-120 LED light will flash once after the configurations are received.

5, Point the A/C original remote to ZXT-120 and press temperature up if your previous set is “cool, 20 C, fan high,

swing”, press temperature down if your previous set is “ cool, 22 C, Fan high, swing”

6, ZXT-120 LED will flash once if it is successful, flash 6 times if failed. (if failed, please repeat the above steps).

Remark: when setting the desired status, besides using temperature, it is also ok to use mode, fan, just to make

sure that one more press it will turn to your desired condition.

ON/OFF KEY Learning

To learn ON code: user should make sure the A/C is at off condition, then press the ON/OFF key once for

learning ON code;

Remark: it will be the last status before you turn off the A/C, user can set it to the desired value every time when

they turn on the A/C, for example: “cool, 23 C, fan auto, swing”. Every time when user turn on the A/C using the

learnt code, it will be the same value as user has learnt.

To learn OFF code, user has to turn on the A/C, then press once ON/OFF key for learning the OFF code.

User may need to record each set of codes status, such as:

 21FRRO&IDQDXWRVZLQJHWF

1 2 3 4

Sem comentários

Remotec ZXT-120 Manual do Utilizador Página 3